Layout Table~~~~1191~1191~~

How to Make Favours~~~~1191~1204~~

Layout Table~~~~1191~1206~~

Step 1~Place required layers of tulle on a flat surface and align edges exactly.

If using a base disk (almond holder), place in centre of tulle before arranging the almond in the middle.~~~1191~1208~~

Step 2~Bring up point A on either side to meet at the top, followed by point B.~~~1191~1209~~

Step 3~Gather in the excess material evenly. Place a small rubber band over the gathered tulle (this will give you two free hands to work with.

Take a length of ribbon and tie as tightly as possible around the 'neck' of the favours. Remove the rubber band.

Separate the layers of tulle by firmly easing the bottom layer in a downward motion and inner layer(s) in an upward motion. This must be done all the way round to give a pleasing effect.~~~1191~1211~~

Step 4~Finally add your choice of flowers by pushing firmly into the centre. If using more than one flowers it is recommended that these are twisted together first.

N.B. Ideally, it should be possible to pick up the finished bomboniera by the flowers – if the flowers fall out, re-tie the ribbon tighter.~~~1191~1210~~